4- Horizontal Stabilizer
Full the elevator out of the
horizontal stabilizer.
Cut away only the
covering both side
A=A'
A
STABILIZER
HORIZONTAL
TOP VIEW
Remove the horizontal stabilizer from the fuselage.
Using the sharp hobby knife, carefully cut away the
covering inside the lines which were marked above.
* WARNING: When removing any covering from the airframe,
please ensure that you secure the cut edge with CA or similar
cement. This will ensure the covering remain tight.
4A
4B
Trial fit the horizontal stabilizer in place. Check the alignment of the
horizontal stabilizer.
If the parts will join, but with a gaps, sand or the rectangular hole on the
fuselage a little at a time until the parts meet exactly with no gaps.
A'
Cut away only the
covering both side
4D
When you are satisfied with the alignment,
use a pencil to trace around the top and
bottom of the stabilizer where it meets the
fuselage.
4C
5