Advertisement
Quick Links
Advertisement
Related Manuals for H-KING SU-27
Summary of Contents for H-KING SU-27
- Page 1 INSTRUCTION M ANUA L...
-
Page 3: Packing List
Packing list: 1: PP Su27 fuselage *1 2: Carbon tube 5*4*650mm*1 3: Pull rod *2 4: Motor mount *1 5: Quick rod adjuster *4 6: Hinge*4 7: M3 screws*4 8: Hook and loop tape*1 Tools: 1: 1.5mm allen wrench 2: Phillips screwdriver 3: Modelling knife 4: Wire cutters 5: Hot melt glue gun and glue sticks... - Page 4 Applying foam glue on 2 pcs nose. Important: Wait 3 mins after applying foam glue, Glue the 3 pcs horizontal fuselages using hot glue then assemble the 2 pcs nose. Make sure 2 pcs sticks. nose trim. Especially for step.
- Page 5 Put the vertical tail on the fuselage and mark the hole for carbon tube. Then put on the carbon tube on the hole’s location. Glue the carbon tube on fuselage using hot glue Cut the horizontal tail using knife. sticks. Assemble all vertical tail on fuselage using hot glue sticks.
- Page 6 Make sure the vertical tail is vertical to fuselage. Assemble the nose on fuselage using hot glue sticks, Reinforce nose using hot glue sticks after assemble. make sure the motor mount location must be flat! Important: Don’t glue too much on motor mount Assemble tail on fuselage using hot glue sticks.
- Page 7 Reinforce all parts from bottom using hot glue sticks Assemble motor on motor mount using motor’s after assemble. screws. Assemble prop on motor. Notice the prop’s direction. Assemble motor mount on fuselage, then reinforce motor mount using a little hot glue sticks. Applying foam glue on nose’s hook and loop tape location, then cut suitable hook and loop tape and stick on the location.
- Page 8 Connect the motor and ESC, then put ESC on hook Place the motor wire through the hole behind motor and loop tape. mount . Install arm on servo and electrify all servos to make Also glue the servo’s wire on fuselage using hot glue sure the arm perpendicular to servo.
- Page 9 Reinforce the horizontal tail using hot glue sticks after assemble. Assemble Quick rod adjuster and install it in hinge, Assemble hinge with foam glue. apply a little No.502 to the nuts. Put on hook and loop tape on fuselage using foam Assemble the battery and receiver using hook and glue and then place another hook and loop tape loop tape.
- Page 10 C of G is on the front of the motor mount 4cm as PP Su27’s elevator and aileron are linkage mode, so shown in the picture above. we need set delta wing mixed control on radio. Then it can super-maneuver flight.