Download Print this page
H-KING FW190 Instruction Manual

H-KING FW190 Instruction Manual

1200mm wingspan

Advertisement

Quick Links

I NST RUC TI O N M ANUA L

Advertisement

loading
Need help?

Need help?

Do you have a question about the FW190 and is the answer not in the manual?

Questions and answers

Summary of Contents for H-KING FW190

  • Page 1 I NST RUC TI O N M ANUA L...
  • Page 3 Packing list: 1: PP FW190 fuselage *1 2: Carbon tube 5*5*940mm *1 3: Pull rod *4 4: Motor mount *1 5: Quick rod adjuster *4 6: Hinge *4 7: M3 screws *4 8: Hook and loop tape *1 9: Wood strip *4...
  • Page 4 Assemble the 3 pcs bottom fuselages using foam Press it after assembly. glue. Assemble the 3 pcs top fuselages using foam glue. Install the carbon tube into the wing. Press it after assembly. Important: don’t glue the carbon tube now!
  • Page 5 Assemble the mid horizontal fuselage on wings using Assemble the 2 pcs wings using foam glue. foam glue. Make sure all parts trim. Make sure 2 pcs wings trim. Assemble the bottom horizontal fuselage on wings Make sure all parts trim. Especially the hole. using foam glue.
  • Page 6: Motor

    Install the carbon strip into the vertical tail and glue it Wait glue dried. Then assemble bottom fuselage into using No.502 glue. the horizontal fuselage using foam glue. Install motor mount on fuselage after assembly using Applying foam glue on top vertical fuselage and foam glue.
  • Page 7: Landing

    Glue the vertical tail using hot glue sticks. Then press the top vertical fuselage into horizontal fuselage. Reinforce all bonding parts using hot glue sticks. Assemble 2 pcs PP sheets on wing using hot glue Especially for weakness point as shown picture sticks.
  • Page 8: Quick Rod

    Install the shortest carbon strip into the hole using Assemble motor on the metal cross using screws. No.502 glue. Assemble the metal cross with motor on the wood Assemble Quick rod adjuster and install it in hinge, motor mount using the 4 pcs M3 screws. apply a little No.502 to the nuts.
  • Page 9 Glue the servo’s wire on wing using hot glue sticks Install hinge into the hole on wing using foam glue. and use Y cord connect the 2 servos on wing. Don’t forget block the hinge with cover and apply glue Install the 2 pcs shorter rods into arm and Quick rod to reinforce.
  • Page 10: Hook And Loop

    Install wood strip in the hole using No.502 glue or hot Same way to install the middle fuselage’s servo. glue sticks. Notice must let pull rod through the hole on wood strip. Install hinge into the hole on vertical tail using foam Also need install 2 pcs wood strips using No.502 or glue.
  • Page 11 Don’t forget glue another hook and loop tape vertical fuselage. after install battery hook and loop tape. FW190 is made by new way, it flying very stable. We can choose 1.75 inch Cowling on motor to make it more beautiful.