Safety And Regulatory Notices - Keysight SL1200A Series Operating Instructions Manual

Safety and Regulatory Notices

DANGER
DANGER
DANGER
DANGER
Scienlab Regenerative AC Emulator – SL1200A Series – Operating Instructions
Using the system can cause danger and damage for life and limb of the
operators or third parties, to the system itself or to other material assets. In
addition to the manufacturer´s countermeasures, the operator must also take
appropriate countermeasures against danger due to residual energy. The
personnel must be briefed about these dangers and the necessary
countermeasures during instruction.
The following general safety precautions must be observed during all phases
of operation of this instrument. Failure to comply with these precautions or
with specific warnings or instructions elsewhere in this manual violates safety
standards of design, manufacture, and intended use of the instrument.
Keysight Technologies assume no liability for the customer´s failure to comply
with these requirements. Please read the also the section
Danger to life in case of misuse at the outputs.
The Scienlab Regenerative AC Emulator does not have its own insulation guard.
If the system emulates an electrical isolation against PE at the output, the local
installation regulations and guidelines must be observed.
This would be in the case of the emulation of an IT network in AC mode, or
generally in DC mode.
Danger to life due to high voltages.
Some components are still supplied with voltage after switching off (wiring color
orange).
Before installation and upkeep, turn off and lock out all external voltage supplies.
Only disconnect or establish electrical connections in a voltage-free condition.
Danger to life due to missing covers!
In case of misapplication, missing protective cover can lead to severe injury, burns or
death in the event of shock and arc flash.
Do not remove cover under load and not operate without cover in place.
After installation and upkeep, the previously removed protective cover must be
replaced.
Depending on the set output voltage and current, the system sometimes releases
large amounts of energy at the output.
Touching the connection bars inside the system or the DUT terminals can occur life-
threatening body currents.
Never touch, connect, or disconnect the connecting lines to the DUT during
active operation.
Danger of arcing.
Safety and Regulatory Notices
Intended Use.
7/51