Clock Section; Status Section - TC Electronic UpCon Manual

Please note that the LEDs on the front of a Up-
Con will display basic status information as long
as the device is powered – see "Front panel indi-
cators" on page 24.
Additional status information can be obtained
using TC Icon, where you can also define how
certain error states should be indicated on the
device.
To display status information about UpCon, go to
Frame / System / Status.
Fig. 24.: UpCon (SDI) Status page
This page will display the following status infor-
mation:
UpCon English Manual (2014-10-07)

Clock section

Source indicator
Indicates the source of the clock signal UpCon is
currently following.
Lock indicator
Indicates wether synchronization has been
achieved. If no synchronization has been
achieved, a red LED will be shown in this field.
Nominal Rate indicator
Shows the detected sample rate of the signal
UpCon is synced to.
Obtaining UpCon status information

Status section

Power indicator
Displays the current state of the UpCon power
supplies.
A power supply failure may be indicated as de-
scribed under "Power Warning parameter" on
page 46.
Power Warning parameter
A failing supply is always indicated by a red LED
on the front panel of the device. TC Icon can also
indicate a failing power supply, depending on the
setting of the "Power Warning" parameter.
"Off" setting
A failing power supply is not reported in the Icon
remote app.
"Warning" setting
A failing power supply is indicated by a yellow
"Power" label in the respective UpCon Frame in-
dicator, and a yellow LED will be shown on the
Frame tab when it is selected.
"Error" setting
A failing power supply is indicated by a red
"Power" label in the respective UpCon Frame
indicator, and a red LED will be shown on the
Frame tab when it is selected.
46