TC Electronic UpCon Manual page 62

GPI 1: Scene Recall section
Enable button
Use this button to enable GPI 1 input for User
Scene Recall.
A "GPI" button that controls the same function
can be found on the Remote – Master page in
the Scene Recall section.
Please note that the Icon user interface is locked
when GPI is used for control.
Function parameter
Use the Function parameter to define the scope
of the GPI recall feature.
The available GPI recall modes that you can set
using the Preset Recall Function parameter are:
Off setting
No Preset Recall using GPI.
2 Presets setting
Select one of two Presets using GPI1.
Select the Preset Bank using the Scene Bank
parameter.
3 Presets setting
Select one of three Presets using GPI1.
UpCon English Manual (2014-10-07)
Select the Preset Bank using the Scene Bank
parameter.
For a description of the "Idle" state, see "Idle
state" on page 60.
4 Presets setting
Select one of four Presets using GPI1.
Select the Preset Bank using the Scene Bank
parameter.
7 Presets setting
Select one of seven Presets using GPI1.
Select the Preset Bank using the Scene Bank
parameter.
For a description of the "Idle" state, see "Idle
state" on page 60.
8 Presets setting
Select one of eight Presets using GPI1.
Select the Preset Bank using the Scene Bank
parameter.
3 Presets DUAL setting
Select one of three Presets using GPI1 and GPI2.
This mode uses simple binary inputs on GPI1
and GPI2 – i.e. 00, 01, 10 and 11.
UpCon remote control
For a description of the "Idle" state, see "Idle
state" on page 60.
Select the Preset Bank using the Scene Bank
parameter.
4 Presets DUAL setting
Select one of four Presets using GPI1 and GPI2.
This mode uses simple binary inputs on GPI1
and GPI2 – i.e. 00, 01, 10 and 11.
Select the Preset Bank using the Scene Bank
parameter.
15 Presets DUAL setting
Select one of fifteen Presets using GPI1 and
GPI2.
This mode uses 8-state on GPI1 and binary on
GPI2.
For a description of the "Idle" state, see "Idle
state" on page 60.
In this mode, the Scene Presets are always re-
called from two consecutive banks – e.g. Bank 1
and Bank 2.
Select the Preset Bank pairs (1+2, 3+4 etc.) using
the Scene Bank parameter.
59