Operating Multiple Computers And / Or Tc Hd Devices In One Network - TC Electronic UpCon Manual

►
Connect your computer and UpCon as de-
scribed in the "Setting up UpCon" chapter.
►
Power up your computer and your UpCon.
► On your computer, launch the TC Icon soft-
ware.
► When you do this for the first time or the sys-
tem configuration has been changed, the fol-
lowing screen will appear:
►
Click "Assign".
► All currently connected TC signal processors
that are supported by the TC Icon software
should be detected and assigned to one of
the eight on-screen slots/locations.
UpCon English Manual (2014-10-07)
►
If a connected device is not detected, please
refer to "Networking basics and trouble-
shooting" on page 32.
►
Click the icon representing the UpCon to ac-
cess it.
Accessing UpCon
Operating multiple
computers and / or TC HD
devices in one network
In a more complex setup with multiple TC Icon
hardware remote controls and/or several net-
worked computers running TC Icon software,
each of these TC Icon units and computers can
be used to connect to TC HD devices (System
6000 MKII, DB6, Loudness Pilot, UpCon) on this
network.
If your setup contains multiple TC HD devices,
you should name these devices unambiguously
so you don't accidentally edit the settings of the
wrong device.
43