TC Electronic UpCon Manual page 55

! Please note that when running 3G Level B,
data stream 1 and data stream 2 need to have
the same bit width so UpCon can de-embed
and process audio. I.e., both data streams
need to contain 8-bit data, or both data
streams need contain 10-bit data). If the bit
widths of the two data streams differ, UpCon
will not be able to de-embed and process au-
dio.
Stream 1 setting
The UpCon will de-embed and embed two of
the up to four available audio groups in stream
1. This is the default setting which is also used
when Advanced SDI mode has not been acti-
vated.
Stream 2 setting
The UpCon will de-embed and embed two of
the up to four available audio groups in stream 2.
Bypass button
Settings: Enabled, Disabled
Use the Bypass button to immediately activate a
hardware bypass of the SDI signal, allowing it to
pass through UpCon unprocessed.
UpCon English Manual (2014-10-07)
Setting up audio and syncing
52