TC Electronic UpCon Manual page 50

Sync indicator
The states and color codes shown here are the
same as those shown by the respective UpCon
Sync LED on the front panel of the device – see
"Sync LED(s) – SDI versions" on page 25.
UpCon English Manual (2014-10-07)
Alert indicator
The states and color codes shown here are the
same as those shown by the respective UpCon
Alert LED on the front panel of the device– see
"Alert LED" on page 25.
Frame Identification parameter
If you are operating a complex system with mul-
tiple UpCon units, you may need to identify one
specific unit quickly. To do so, select the respec-
tive Frame using TC Icon software and then use
the Frame Identification parameter to have that
Frame identify itself with blinking Alert LEDs as
follows:
"Off" setting
This is the default setting. The Alert LED oper-
ates as described in "Alert LED" on page 25.
"Green/Off", "Yellow/Off", "Red/Off", "Green/
Yellow", Green/Red", "Yellow/Red"
The Alert LED on the front panel of the respec-
tive Frame will blink in the chosen color/color
combination, while the Alert indicator field will
read "LED blinking".
Obtaining UpCon status information
Signal indicator
The states and color codes shown here are the
same as those shown by the respective UpCon
Signal LED on the front panel of the device– see
"Signal LED" on page 26.
47