Upcon Algorithm - Auto Page - TC Electronic UpCon Manual

UpCon algorithm – Auto page
Fig. 41.: UpCon algorithm – auto page. The
green UpCon indicator "LED" shows
upconversion is currently active.
UpCon English Manual (2014-10-07)
Auto page – Setup section
Detect parameter – Detection modes
To avoid the need for metadata to control for-
mat switching, UpCon's detector makes use of
advanced sensing with appropriate hysteresis
and timing computations. The Detect parameter
sets the conditions for engaging or disengaging
upconversion.
The 24 bit, 20 bit and 16 bit settings enable de-
tection based on the presence of dither.
The -60, -50, -40, -30, and -20 dB settings en-
able detection based on audio level.
When the Input Select parameter on the Main
page has been set to "Main Only", the automa-
tion system measures the Center, L and R Sur-
round inputs. For instance, if the Detect param-
eter is set to "16 bit", UpCon reads dither on the
C, LSr and RSr inputs. If dither is available on
any of them, UpCon assumes that a 5.1 signal is
available, and cross-fades into 5.1 bypass.
Note that this automation mode gives priority to
a 5.1 signal, and that outputs are never muted.
When no 5.1 signal is present, upconversion is
engaged.
When the Input Select parameter on the Main
page has been set to "Aux Priority", the automa-
tion system measures the L and R Aux inputs.
For instance, if the Detect parameter is set at
"-60 dB", UpCon reads the audio signal on the
Aux inputs. If audio is available on any of them,
The UpCon algorithm
UpCon assumes that a 5.1 signal is not available,
and cross-fades into upconversion based on the
Aux inputs.
Note that this automation mode gives priority to
the Aux input, though the 5.1 inputs can be used
simultaneously with the Aux inputs to add to the
upconversion. When no signal is present on the
Aux inputs, upconversion is bypassed.
Dissolve parameter
Use the Dissolve parameter to set the crossfade
time between 5.1 and upconversion. The green
UpCon indicator reads out the upconversion sta-
tus before the Dissolve time is applied.
! The outputs of UpCon are never muted. Dis-
solve only sets the duration of the crossfade.
96