Style Page - TC Electronic UpCon Manual

Style page

Fig. 39.: Style page
Use the parameter on the Style page to fine-tune
the way a signal is being processed by the Up-
Con module.
UpCon English Manual (2014-10-07)
Front section
Reference Level parameter
The Reference Level parameter is used for input
level scaling, mainly affecting the Contour Style
settings.
► For broadcast, use a setting between -22 and
-18 dBFS.
►
For film, use a setting between -20 and
-24 dBFS
►
For music, use a setting between -14 and
-20 dBFS.
C Contour Style parameter
Use the C Contour Style parameter for Center
channel extraction.
L/R Process parameter
Use the L/R Process parameter for suppression
of the Center channel in L/R. You should set this
parameter in tandem with the front channel gain
parameters.
LFE Proc. Hi Cut parameter
Use the LFE Proc. Hi Cut parameter to set the
cut-off frequency for the LFE extraction low-
pass filter.
The UpCon algorithm
LFE Slope parameter
Use the LFE Slope parameter to set the cutoff
slope ("steepness") for the LFE extraction low-
pass filter.
92