Disassembly Procedure For Front Section - TC Electronic Finalizer Epress Technical & Service Manual

Disassembly Procedure for Front Section

1. Turn Off Power and Disconnect Power Cord.
2. Loosen 5 screws, see fig. 1, and remove the top cover.
3. Disconnect front connector J1, see fig. 2.
4. Remove the side panels by unscrewing 4 screws at each side, see fig. 4.
5. Remove the front section.
6. Pull off the seven pot knobs by hand.
7. Place the front profile horizontally with the buttons facing down.
8. Pull out the two white PCB guides. Opening up the profile a little will lighten
the pressure at the PCB guides, see fig. 5.
9. Note: The Power button is loose in the profile after removing the guides.
10. Use the ribbon cable to lift up the front board assembly a little and then slide it out
gently at the end named "OUTPUT" .
______________________________________________________________________________________________________________________________________________________________________________
__________________
TC Electronic A/S
Fig. 4: Screws at side panels.
4 screws
Fig. 5: Front profile shown from the VALUE knob end.
Finalizer Express Service manual
Top view
Press out a little
P C B
g u i d e s
4 screws
page 8