Front Panel Reset Button - TC Electronic UpCon Manual

Signal LED
The Signal LEDs indicate if audio streams are re-
ceived and processed by UpCon.
Detection for the Signal LEDs and GPO occurs
at the input.
LED color / Status
indication
Off No audio signal (above
-70 dBFS) has been detected.
Green An audio signal above
-70 dBFS has been detected.
Yellow An audio signal above -1 dBFS
has been detected.
UpCon English Manual (2014-10-07)

Front panel reset button

The Reset button on the front panel can be used
to reset the IP address of a UpCon unit or to
reset Ethernet communication between UpCon
and a computer when a communication error
has occurred.
UpConstatus indicators and ports
Resetting the IP address
of a UpCon unit
It may be necessary to reset the IP address of a
UpCon unit. To do so, proceed as follows:
►
Switch off UpCon by disconnecting both
power supplies.
►
Insert a straightened paper clip or a similar
object into the "Reset" hole on the front panel
until it touches the button behind the panel.
►
Boot the UpCon by connecting one or both
power supplies while still holding the straight-
ened paper clip onto the Reset button.
will boot using its default IP address.
UpCon
The default IP address is 192.168.1.[xx], where
[xx] is the last two digits of the device's serial
number as printed on its back.
26