Table of Contents
Advertisement
Scanning / rescanning a
network for devices
The scenario described above covers the first
time you boot up your system or when no con-
nected units are assigned.
When...
►
you make changes to your setup,
►
when devices are powered up or down, or
►
if there are connection errors, these may not
be detected immediately.
In this case, you should scan the network again.
UpCon English Manual (2014-10-07)
To scan a network for devices:
►
In the TC Icon software, go to Setup / Devices
►
Click the Detect button.
For further information, see "Devices page" on
page 83.
In the following sections of this manual, we as-
sume that you are operating a basic system with
only one UpCon connected.
Accessing UpCon
44
Advertisement
Table of Contents
