Front Panel - TC Electronic M-ONE User Manual

POWER button
Power on/off.
IN LEVEL knob
Adjusts the Input level.
At center position a relay will
switch the Input circuit
between consumer and pro
level. This will insure optimal
Input gain range and superb
"signal to noise" ratio is
achieved.
MIX knob
Adjusts the global mix between
dry and wet signal.
Fully clockwise is 100% effect.
EFFECT BAL knob
Adjusts the balance between
the two Engines.
INPUT Meters
The Peak meter shows the
Input level of left/right
channels.
The meter range is:
0, -3, -6 ,-12, -18, -24, -40.
OVERLOAD LEDs
The OVERLOAD LEDs
indicate one of two situations:
• The Input level is too hot
and therefore overloading.
• There is an internal DSP
overflow.
The Overload LED is lit when
1 sample is @ -1dBFS.
6

FRONT PANEL

INPUT - Analog/Digital
Indicates whether the M•ONE
is set to analog or digital Input.
When set to digital Input, the
Sample Rate automatically
switches to DI.
In case of no or unacceptable
clock the "Digital" and "DI" icon
will be blinking.
ANALOG/DIGITAL LED
ANALOG/DIGITAL indicator
states the selected Input.
Input type is selected in the
"I/O Setup" menu.
SAMPLE RATE indicator
The SAMPLE RATE indicator
shows the clock source and
the incoming master clock.
The "Digital In" icon will be
blinking if no clock or
unacceptable clock is found.
ROUTING indicator
Indication of what Routing
mode the M•ONE currently is
using.
ALGO Indicator
Shows the currently used
algorithms in each of the two
Engines.
DYNAMIC meters 1+2
These two meters show the
gain reduction when an Engine
is running Dynamic algorithms.
The Dynamic algorithms are:
Compressor, Limiter, Gate,
Expander and De-esser.
DISPLAY
Displays the preset number
and the preset type:
Factory or User.
EDITED icon
This icon will be lit as soon as
the current recalled preset has
been modified.
FACTORY/USER icon
Shows whether you are
operating in the Factory or the
User bank.
MIDI IN icon
Shows any incoming
MIDI activity.