Chapter 3 Installation; Inspect Shipping Contents; Mechanical Installation - Ametek CEM/Humox User Manual

This chapter shows you how to install your sensor components, and includes the
following sections:
•

Inspect Shipping Contents

•

Mechanical Installation

• Wiring
• Series 2000 Control Unit
• Option Card Installation
Inspect Shipping Contents
Remove any packing material from the sensor and check for damage. If any is
found, notify the shipper.
Mechanical Installation
This section describes how to perform the mechanical installation portion of your
system installation. This includes the following:
• Mounting the Wet and Dry CEM/O
• Sample Gas Requirements/Connections
• Calibration Setup
INSTALLATION
The operations in this chapter should only be performed by qualified
service personnel experienced with electrical safety techniques. There
are no operator serviceable components inside the CEM/Humox sys-
tem. Never service the sensor unless power has been removed and it
has been allowed to cool for at least one hour. Also, always use gloves
when working on the sensor.
Sensor
2
|
Installation 3-1