Enter a Password
5-6 | Thermox CEM/Humox Analyzer
System passwords are created using the Setup key. Please see the "Pass-
word" section in the Setup Key chapter for information on defining or
disabling a system password.
NOTE
If a system password is enabled, you will be required to correctly enter this password
before accessing certain Calibrate key functions.
When you select the Calibrate key, you will be prompted to enter your system
password (assuming a password has been defined):
Enter password
•
Enter the four digit system password. To protect the identification of the pass-
word, the numbers you enter will not be displayed.
You will then be allowed to access Calibrate key functions.