Configuring With At Commands - Sierra Wireless AirLink GX Series Hardware User's Manual

AirLink GX Series Hardware User Guide
50
To access AirVantage Management Service:
1. Connect a laptop to the GX Series device with an Ethernet cable.
2. Log in to ACEmanager.
3. Go to the Services tab and ensure that AVMS is enabled and the server URL
is http://na.m2mop.net/msci/com. If this is not the case, enter the correct
URL, click Apply and then click Reboot.
4. In your browser, go to
5. Follow the instructions in the online AVMS documentation to register your
device.
Figure 3-4: AirVantage Management Service initial screen

Configuring with AT Commands

You can also configure GX Series devices using AT commands over the RS-232
serial port or the USB port (configured as a virtual serial port). All the commands
are listed in the ALEOS Software Configuration User Guide.
In ACEmanager, mouse over a red AT to the left of a listing to see a popup
showing the AT command for that item.
• Most AT commands are prefaced with AT. Exceptions are noted in the ALEOS
Software Configuration User Guide.
• The acceptable format and parameters are listed with each command in the
ALEOS Software Configuration User Guide.
• If you enter a recognized AT command, the GX Series device responds with
"OK." If the command is wrong, the GX Series device responds with "ERROR"
or "Unsupported."
http://na.airvantage.net/start and log in.
4114008