Installing The Sim Card-Dual Ethernet X-Card Present - Sierra Wireless AirLink GX Series Hardware User's Manual

AirLink GX Series Hardware User Guide
24
tight so that the seal underneath the decorative black cover is tight against
the device.
9. Re-install the screw nuts you saved in step 1 to either side of the serial port.
(Finger tight is sufficient.)
Note: The screw nuts must be re-installed to maintain the IP rating for the AirLink device.
screw nuts
Figure 2-11: Replacing the screws and nuts (I/O X-Card installed)
Installing the SIM Card—Dual Ethernet X-Card
present
Important:
Failure to follow these instructions carefully may damage the X-Card and
void the warranty agreement.
To install a SIM card in a GX Series device with a Dual Ethernet X-Card installed:
1. Remove the four screws used to secure the black decorative cover. Use a
2 mm Allen (hex) wrench or a Phillips #1 screwdriver, depending on the screw
type used on the black decorative cover. Save the screws for reinstallation.
4114008