At Commands Reference; Managing The I/O Interface With At Commands - Sierra Wireless FX30 User Manual

C: AT Commands Reference
This appendix documents the AT commands that are specific to the FX30. For a
complete list of AT Commands for the radio modules available for the FX30, refer to
the
4118047).
In addition, the AT Commands in
Note: Parameters in angled brackets < > are mandatory. Parameters in square brackets [ ] are
optional.
Managing the I/O Interface with AT
Commands
See AT!FWD?GPIO and AT!FWD=GPIO documentation in
mapping in
Because some FX30 GPIOs are driven by an I/O expander, do not use standard
AT+WIOR/WIOW AT commands for the FX30.
Warning:
Using this command could make the FX30 inoperable.
Here are some AT command examples for GPIOs:
Table C-1: AT command examples
Turn on the green User LED
Turn off the green User LED
Read the push button state
Read the analog input value (in mV)
Rev 4 March 2019
WP8548/WP75xx/WP76xx/WP77xx AT Command Reference
Table D-1 on page 74.
Most FX30 GPIOs are preconfigured. Do not use the AT+WIOCFG command!
To...
65
Table C-2 are specific to the FX30.
Table
Use...
AT!FWD=GPIO,48,0
AT!FWD=GPIO,48,1
AT!FWD?GPIO,7
AT!MADC?5
C
(document number
C-1, and I/O
41110030