Printing A Network Interface Status Page - Kyocera FS-C8100DN Advanced Operation Manual

Using the Operation Panel
2 Enter the submenu by pressing
the selection changes.
3 When >>IP Address is displayed, press [OK]. A blinking cursor
(_) appears at the last digit.
4 Press
to move the cursor right and left.
5 When the IP address is entered, press [OK].
6 Press
subnet mask address.
7 Then, press
gateway address.
8 Press [Menu]. The display returns to Ready. You can print a network status page to confirm that the
IP address, subnet mask address, and the gateway address have been properly set. To print a
network status page, refer to Printing a Network Interface Status Page on page 2-28.

Printing a Network Interface Status Page

You can have your printer print out a network status page when the printer prints the status page.
The network status page shows the network addresses, and other information under various
network protocols about the network interface card. The default setting is Off (print disable).
NOTE:
interface card. For details, refer to the manual for the network interface.
1 Press [Menu].
2 Press
2-28
or to increase or decrease, respectively, the value at the blinking cursor. Use
or to move to Subnet Mask. Perform the same procedure to complete entering the
or to move to Gateway. Perform the same procedure to complete entering the
Printing out a network interface status page may not be possible with the optional network
or repeatedly until Interface > appears.
. Each time you press or ,
>>DHCP
On
>>BOOTP
On
>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
>>Gateway
000.000.000.000
>>IP Address
000.000.000.000
and