Changing The Interface Parameters; Changing Parallel Interface Mode - Kyocera FS-C8100DN Advanced Operation Manual

Using the Operation Panel

Changing the Interface Parameters

This printer is equipped with a parallel interface, a USB interface and a network interface. An
optional serial interface and a network interface can be installed. Various printing environment
parameters such as the default emulation can be changed independently on different interfaces by
using the printer's menu selection system. Select the interface to apply the changes in the
procedure described below.
NOTE:
be received. The printer automatically selects the interface.

Changing Parallel Interface Mode

The parallel interface supports a bi-directional/high-speed mode according to IEEE standards.
Normally, this interface is used under the default setting Auto. For details, refer to Parallel Interface
on page 4-3. After setting the interface, be sure to reset the printer or turn the power off at least
once. The new setting will be enabled thereafter. You can select from the following:
•
•
•
•
1 Press [Menu].
2 Press
If the interface is other than parallel, press [OK]. A blinking
3
question mark (?) appears.
4 Press
5 Press [OK] again. The question mark disappears.
6 To change the parallel interface mode, press
7 To change the communication mode, press [OK]. A blinking
question mark (?) appears.
8 Press
9 When the desired communication mode is displayed, press [OK].
10 Press [Menu] to exit the menu selection.
2-24
This interface selection described below does not select the interface from which data will
Auto (default)
Normal
High speed
Nibble (high)
or repeatedly until Interface > appears.
or repeatedly until Parallel appears.
or to scroll through the following communication modes:
Auto
Normal
High speed
Nibble (high)
Interface
? Serial
Interface
? Parallel
. The current communication mode appears.
>Parallel I/F
? Nibble (high)