Kyocera FS-C8100DN Advanced Operation Manual page 49

Default Font
You can select the default font for the current interface. The default font can be one of the internal
fonts or a font that is downloaded to the printer memory or stored in a memory card, hard disk or
option ROM.
In this menu, you can also set the type and pitch for Courier and Letter Gothic; as well as to print a
font list.
1 Press [Menu].
2 Press
3 Press
4 To select an internal font, make sure that Internal is displayed
and press
press [OK], then press
To select an optional font, press [OK] while >Font Select > is
displayed. Press
then press [OK]. Press
operation only when optional fonts are installed in the printer.
The letter before the number indicates the location of the font, as shown below:
I
S
M
H
O
5 Press [OK]. A blinking question mark (?) appears.
6 Press
fonts, refer to Printing Lists of Fonts on page 2-36.
7 When the desired font is displayed, press [OK].
8 Press [Menu]. The display returns to Ready.
Selecting Regular or Dark Courier/Letter Gothic
Courier or Letter Gothic font thickness can be selected as Regular or Dark. In the procedure
below, it is assumed that Courier is selected. The procedure is the same for Letter Gothic.
1 Press [Menu].
2 Press
or repeatedly until Font > appears.
. Press or until >Font Select > appears.
. The display changes. If Internal is not displayed,
or until it appears.
or repeatedly until Option appears and
next to display the font selection shown above. You can perform this
Internal font
Soft (downloaded) font
Fonts in optional memory card
Fonts in RAM disk or optional hard disk
Fonts in optional ROM (API)
or repeatedly until the desired font number appears. For font numbers of the internal
or repeatedly until Font > appears.
Using the Operation Panel
Font
>Font Select
Internal
>> I000
>>?I000
Font
>
>
>
2-33