Kyocera FS-C8100DN Advanced Operation Manual page 42

Using the Operation Panel
For example, to change baud rate from 9600 to 115200, display
the baud rate menu following the above procedure. When the
display shows baud rate, 9600 (bps), press [OK]. A blinking
question mark (?) appears.
7
Press
exit the menu selection.
NOTE:
rate to 115200 and encounter communication problems, select a lower baud rate.
Changing Network Interface Parameters
This printer supports TCP/IP, NetWare and AppleTalk protocols. In addition, you can install the
optional network interface card in the option interface slot.
Using the operation panel, you can:
•
•
•
•
1 Press [Menu].
2 Press
3 If the current interface is other than Network, press [OK]. A
blinking question mark (?) appears.
If the optional network interface card is installed in the printer,
Option will be displayed. The setting procedure is basically the
same even in this case.
4 Press
5 Press [OK] again.
2-26
or to scroll through values. When 115200 is displayed, press [OK]. Press [Menu] to
Some computers may not be able to handle a baud rate of 115200 bps. If you set the baud
Activate or deactivate TCP/IP, NetWare, and AppleTalk
Activate or deactivate DHCP
Enter IP address, subnet mask address, and default gateway address
Determine whether to print a network status page when the printer is turned on
or repeatedly until Interface > appears.
or repeatedly until Network appears.
>Baud Rate
? 9600
Interface
? Parallel
Interface
? Network
>
>