Kyocera FS-C8100DN Advanced Operation Manual page 38

Using the Operation Panel
2 Press
3 Press
4 Press
appears.
5 Press
6 Press
appears.
7 To change the maximum disk space, press [OK]. A blinking
cursor (_) appears.
8
Press
to move the cursor right and left.
9 When the desired size is displayed, press [OK].
10 Press [Menu]. The display returns to Ready.
Maximum Space Assigned to Permanent Code Jobs
This changes the hard disk space that holds permanent code jobs. You can change the maximum
space from 0 to 9999 (megabytes). The actual maximum size depends on the size of free hard disk
space. The default size is 1/6 of the total hard disk space, rounded off in units of 50 MB. For
example, if the total hard disk space is 10 GB, the default size is 1550 MB.
1 Press [Menu].
2 Press
3 Press
4 Press
5 Press
6 Press
2-22
or repeatedly until e-MPS > appears.
.
or repeatedly until >e-MPS Configuration >
.
or repeatedly until >>Temp. Code JOB Size
or to increase or decrease, respectively, the value at the blinking cursor. Use
or and select e-MPS >.
.
or and select >e-MPS Configuration >.
.
or and select >>Perm. Code JOB Size.
e-MPS
>e-MPS
Configuration
>>Temp. Code JOB
Size 1550MB
>>Temp. Code JOB
Size 1550MB
and
e-MPS
>e-MPS
Configuration
>>Perm. Code JOB
Size 1550MB
>
>
>
>