Table of Contents
Advertisement
All manuals and user guides at all-guides.com
5-35. Tractor (Figure 5-31)
a. Removal
1. Remove power cord (1). Open cover (2).
2. Remove paper from printer.
3. Unlock right tractor (3) and left tractor (4).
4. Loosen setscrew (5).
5. Remove bushing (6) from spline shaft (7).
6. Remove screw (8) and washer (9).
7. Unscrew support shaft (10) until it clears knob (11).
8. To remove right tractor:
(a) Slide spline shaft (7) to right and slip belt (12) off feed pulley (13).
(b) Completely remove spline shaft (7).
(c) Lift out support shaft (10) and both tractors (3 and 4).
(d) Slide right tractor (3) to right and off support shaft (10).
9. To remove left tractor:
(a) Remove paper motion sensor per paragraph 5-36a.
(b) Slide spline shaft (7) to right until it clears tractor (4). Slip paper feed belt (12) off
motor pulley (13) if necessary.
(c) Remove screw (14).
(d) Separate cable clamp (15) from tractor (4).
(e) Lift out tractor (4).
b. Installation
1. To install left tractor:
(a) Place tractor (4) in printer.
(b) Position cable clamp (15) on tractor (4).
(c) Install screw (14).
(d) Slide spline shaft (7) into tractor (4). Make sure specially identified nub on both
tractor belts are in the same location relative to spline shaft.
(e) Install paper motion sensor per paragraph 5-36.
P6040/P6080 Corrective Maintenance
5-63
Advertisement
Chapters
Table of Contents
