Processor/memory complex installation
Remove four screws ( 1 ) that secure the complex to the chassis. These screws are
7.
located on the right side of the chassis as you face the back of the system.
Rotate the two extraction levers ( 1 ) on the sides of the module to eject it from
8.
the Sideplane connector.
9.
Carefully remove the module and place it on a clean ESD-protected surface.
Complete the following actions to install the processor/memory complex.
1.
Orient the Processor/Memory Complex such that the high-density connector
used for attachment to the Sideplane is positioned to slide into the
Processor/Memory Bay.
2.
With the two extraction levers in the open position (ends pointing towards you),
slide the Processor/Memory Complex fully into the Processor/Memory Bay.
3.
Push the extraction levers toward the chassis so that they seat the
Processor/Memory Complex into the Sideplane inside the chassis. Be sure that
FRU information (service only)
179