Load batch parameters
You can load previously saved AMIDiag batch diagnostic test parameters by choosing
this option. The following appears when you select this option:
Press <Enter> to accept the default batch parameter file (AMIDIAG.INI) or type the
appropriate AMIDiag batch parameter filename. You can use any valid filename. The
filename extension does not have to be .INI. You can then run the AMIDiag diagnostic
tests that are specified in this file by pressing <F10>.
Save batch parameters
You can save all batch mode parameters, selected tests, selected devices, and error
logging information to an AMIDiag batch parameter file via this option. You can then
load this ASCII file later and use the same saved options to run another AMIDiag test
session later. This option allows you to use the same test parameters every time you
perform an AMIDiag session. The following appears when you select this option:
67
Diagnostics