Table of Contents
Advertisement
Hot-swap option installation
Hot Swap Controller (HSC)
The Hot Swap Controller (HSC) resides on the T-docking board. The primary
functions of the HSC are as follows:
•
Implements the SAF-TE command set
•
Controls the fault lights
•
Provides a path for management information through the SCSI
•
Retrieves drive fault status, backplane temperature, and fan failure information
through IPMB
•
Queries the status of the power distribution board by retrieving information from
the BMC through the IPMB
•
Controls drive power-on and power-down, facilitating hot-swapping.
Chassis Bridge Controller (CBC)
The CBC Controller resides on the Legacy I/O board. It serves as a bridge between the
internal Intelligent Platform Management Bus (IPMB) and the external Intelligent
Chassis Management Bus (ICMB). The internal IPMB transports server management
information within a system, and the external ICMB transports server management
information between various chassis in a cluster configuration that can contain
multiple servers and peripherals.
This section contains the information necessary to install, remove, and replace the hot-
swap options in your server. The options in the following list are the only options
which you can install, remove, or replace. A qualified technician must service all
other options.
Statement 14
CAUTION:
Hazardous voltage, current, and energy levels might be present. Only a qualified
service technician is authorized to remove the covers where the following label is
attached.
User replaceable options are:
•
172 mm Fan
•
120 mm Fan
•
Hard Disk Drive
•
Power Supply
•
PCI Adapters
143
Installing components
Advertisement
Table of Contents
