Table of Contents
Advertisement
Parameter
Test This Device
Select YES to run the USB Keyboard Test. The default is YES if AMIDiag
found a USB keyboard.
PnP Test
Select YES to run the USB Keyboard PnP (Plug and Play) Test. The
default is YES if AMIDiag found a USB keyboard. This test makes sure
that the USB keyboard plug and play feature works properly. The Plug
and Play feature automatically configures the USB device when the
device is attached to the computer.
USB mouse tests
This test performs USB Mouse tests on both UHCI and OHCI systems.
To run the test, select Device Test from the USB menu. Select USB Mice test and press
<Enter>. There are three sub tests available for USB mice test:
•
USB Mouse Control Test,
•
USB Mouse Sensitive Test, and
•
USB Mouse PnP Test.
Parameter
Test This Device
Select YES to run the USB Keyboard Test. The default is YES if AMIDiag
found a USB keyboard.
Sensitivity Test
Select YES to run the Sensitiv ity test.
PnP Test
Select YES to run the USB Mice PnP (Plug and Play) Test. The default is
YES if AMIDiag found a USB mouse. This test makes sure that the USB
mouse plug and play feature works properly. The Plug and Play feature
automatically configures the USB device when the device is attached to
the computer.
USB hub test
This test verifies the functionality of an external USB Hub. It does not test the built in
Root/Hub on the USB controller.
The following test parameters appear:
Parameter
Test This Device
Select YES to run the USB Hub Test. The default is YES if AMIDiag
found a USB Hub.
Port Number X
These are the parameters for each port on the external hub.
Device Connected
Select YES if there is a device attached to this port on the USB Hub. The
default is YES if AMI Diag found a USB device attached to the port.
Device Speed
Select UNKNOWN if you are not certain the protocol speed of the USB
device. Most USB Keyboards and USB Mice use a LOW speed setting
(10kbps), where most USB Mass Storage Devices (floppy drives,
CDROMs, etc.) use the FULL speed setting. IF AMIDiag detects a
device attached to the port, it should set this parameter to the detected
value.
Action
Action
Action
Diagnostics
53
Advertisement
Table of Contents
