Table of Contents
Advertisement
LS120 FD diskette drive
LS120 FD diskette drive removal
2.
If the front bezel is not already removed, remove the bezel.
3.
Align the hard drive bay such that the connector side is facing into the chassis and
push the bay into the front of the chassis.
4.
Ensure the drive bay seats into the front connector on the T-Docking Board.
5.
Replace the four screws at the top and bottom of the bay.
6.
Replace any disk drives into drive bay as required.
7.
Replace the front bezel.
The LS120 FD Drive is housed in a two-piece, drive carrier assembly. The assembly is
accessible when the top cover is removed. The following sections describe how to
remove and install the drive.
Complete the following actions to remove the LS120 FD diskette drive.
Note:
•
Read "Before you begin" on page 136.
•
Read "Safety information" on page 257 .
•
Read "Handling electrostatic discharge-sensitive devices" on page 260.
1.
Remove the top cover. See "Top cover removal" on page 168.
1
Cable connector
2
Thumbscrew
3
Cable connector
4
Tab
5
Slots
Disconnect the drive's data and power cables ( 1 and 3 ) from the able adapter
2.
PCB at the rear of the drive.
FRU information (service only)
173
Advertisement
Table of Contents
