Memory Board Installation - IBM xSeries 380 Hardware Maintenance Manual

7.
8.

Memory board installation

Note: There are two memory boards in the Processor/Memory Complex. They are
Complete the following actions to install a memory board.
Note:
1.
186
Hardware Maintenance Manual: xSer ies 380
Simultaneously pull up on the extraction levers to disengage the memory board
from the processor baseboard ( 1 ).
Note: Both extraction levers must be raised evenly while disengaging the
memory from the Processor Baseboard. The memory board must remain
parallel to the Processor Baseboard during extraction.
Place the memory board on a clean ESD-protected surface.
plugged into the top and underside of the processor baseboard. Steps 2 on
page 187 through 9 on page 187 describe the installation process for one
memory board.
• Read "Before you begin" on page 136.
• Read "Safety information" on page 257 .
• Read "Handling electrostatic discharge-sensitive devices" on page 260.
Remove the Processor/Memory Complex as described in "Processor/memory
complex removal" on page 177 .