Table of Contents
Advertisement
16. Grasp the T-Docking board by the right-rear edge and lift up to remove it from the
T-Docking board installation
Complete the following actions to install the T-docking board:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Align the AC input bracket and tighten the two screws to secure the bracket.
11. Install the DC-DC converter's retaining bracket between the 120 mm fan housing
12. Connect the data cables to the CD-ROM and LS120 diskette drives.
13. Install the power supplies.
14. Install the top cover as described in "Top cover installation" on page 170.
210
Hardware Maintenance Manual: xSer ies 380
chassis.
Remove the U-shaped pull handle on the original T-docking board and attach to
the replacement board.
Place the T-Docking board into position inside the chassis. Take care to locate the
board over the alignment pin in the middle and not over the SCSI cable.
Engage the connector on the side of the T-Docking Board to the Sideplane. Be
sure that the connector on the T-Docking Board is aligned correctly with the
Sideplane before pressing the board down.
Connect the 172 mm fan cables to the underside of the T-Docking board. You can
access the connection from within the emptied Hard Drive Bay. Make sure that
the connector latches are secure.
Reinsert the Hard Drive Bay and secure it with the four front screws.
Reinsert the two hot swap drives into the Hard Drive Bay.
Connect the SCSI interconnect cable to the I/O Baseboard and T-Docking board.
Connect the 120 mm fan, CD-ROM, LS-120 power cable into the top of the T-
Docking Board.
Install the DC-DC converter to the top of the T-Docking board.
and the AC input bracket.
Advertisement
Table of Contents
