Kubota XN12-8 Operation Manual page 61

Control
Joysticks and Pedals
Boom swing lever
This lever controls the hydraulic oil flow and
direction in the auxiliary hydraulic circuit.
(A) ......Boom swing right
(B) ......Boom swing left
Auxiliary hydraulic pedal
This right pedal is used for hammer operation.
Note: Make sure you have and correctly installed
the breaker device. Step on the pedal forward,
the breaker will start to work, release the pedal,
and the breaker will stop.
Chassis telescopic control pedal
This pedal is used to control the outward
extension and inward contraction of the
crawler of the lower frame.
A. The track extends to both sides.
B. The track retracts inward.
Pedal lock
When the pedal is not in use, hold the pedal
cover at locking position. If it's not locked, the
accidental depressing of pedal will probably
result in accidents.
l Flip the cover to the outside to lock the
foot pedal so that it cannot be stepped on.
l Flip the cover to the inside to expose the
pedals, and then you can step on the pedals.
2-13
Warning