Kubota XN12-8 Operation Manual page 41

Safety
Precautions for Maintenance
● Upon detection of any visible damage on
the appearance, please replace the
"periodically replaced critical safety parts",
even if the designated replacement period
is not reached.
Jumper Start with Battery Charging Cable
● To start the engine by battery charging
cable, ensure to connect the cable correctly
as per following procedure. The incorrect
connection of cable can cause discharging
and battery explosion.
● Keep the "Malfunctioned machine" and
"Rescue machine" away from mutual
contact.
● Never touch the positive (+) and negative
(-) electrodes of battery charging cable
with each other or with the machine.
● During connection, firstly connect the
positive electrode of battery charging cable
to positive
disconnection, firstly disconnect the
negative (-) terminal (grounding terminal)
from the negative cable.
● Ensure to connect the cable clamps
securely.
● Connect the last clamp of battery charging
cable to a place as far as possible from the
battery.
● To start the engine with battery charging
(+) terminal. During
cable, always wear goggles and gloves.
● Use the battery charging cable and clamps
of dimensions suitable to the battery
capacity. Never use damaged or corroded
battery charging cable or clamps.
● Ensure that the battery capacity is same for
the "Malfunctioned machine" and "Rescue
machine".
Asking Ken stone Heavy Machinery Service
Dealer for Welding Repair
The welding operations, if necessary, must be
fulfilled by competent personnel in a working
site with complete equipment. To prevent
damaging any machine part by over-high
current or electric spark, please abide by the
following precautions.
● Disconnect the battery cables before
electric welding.
● Do not apply 200V or higher voltage
continuously.
● Connect the grounding point within 1m
reach from the welding area. Do not
connect the grounding terminal near the
electronic control device/instrument or
connector.
● Ensure there is no seal ring or bearing
between welding area and grounding
terminal.
● Do not connect the grounding terminal to
1-33