Overview - Kubota XN12-8 Operation Manual

Maintenance

Overview

Overview
Maintenance Overview
To maintain the good status and long-term
serviceability of the machine, please fulfill the
checking and maintenance correctly and safely
abide by the procedures recommended by this
manual.
Based on the total operating time of the
machine, the checking and maintenance items
can be divided into several groups: Every 10h
(Walk-around checking and daily routine
checking), every 50h, and every 250h. Please
refer to the reading of hour meter to determine
the checking and maintenance timing. The
items for which the checking and maintenance
intervals can't be determined are listed in
column "As necessary".
When the machine is operated in extremely
severe environment (Dusty or high temperature
environment), fulfill the checking and
maintenance ahead of the periods specified by
maintenance schedule.
Maintenance Precautions
Do not fulfill any other checking or
maintenance item not listed in this manual.
For the items not listed in this manual, please
ask your sales or service dealer for help.
Keeping Machine Clean
● Clean the machine before checking and
maintenance. Keep the machine clean.
● Stop the engine before cleaning the
machine. Cover the electric parts against
water ingress. The water ingress into the
electric parts will probably result in short-
circuit or malfunction. Do not clean the
battery, electronic control units, sensors,
connector, or operating room by water or
steam.
Fuel, Lubricating Oils, and Greases
● Select fuel, lubricating oils, and greases as
per the "Fuel and Lubricant Table".
● Use the water-free fuel, lubricating oil, and
grease. Take cautions to eliminate the
ingress of dusts during replacement or
filling of fuel, lubricating oil, and grease.
● Store the fuel, lubricating oil, and grease in
designated location and guard against the
ingress of water and dusts.
Precautions for Refueling
● If the fuel filler port is installed with a
filter screen, do not remove the filter
screen during refueling.
● Please ensure to tighten the fuel tank cap
after refueling.
● The refueled volume shall not exceed the
designated fuel volume.
No Cleaning of Engine Parts by Fuel
It's prohibited to clean engine parts by fuel. Use
5-2