Kubota XN12-8 Operation Manual page 34

Safety
Precautions for Maintenance
No Access of Non-Authorized Personnel
During operations, the non-authorized
personnel are prohibited to access the working
zone. Take cautions during grinding, welding,
and use of hammer. You will probably be
injured by the flying fragments from the
machine.
Preparations of Working Zone
Select a stable and level working zone. Ensure
the appropriate illumination conditions. For
indoor operations, keep well ventilated.
Remove obstacles and dangerous goods. Clear
slippery areas.
Always Keeping Clean Machine
Please clean the machine before maintenance.
Stop the engine before cleaning the machine.
Cover the electric parts against water ingress.
The water ingress into the electric parts will
probably result in short-circuit or malfunction.
Do not clean the battery, electronic control units,
sensors, connector, or cab by water or steam.
Stop of Engine before Maintenance
While the machine is working or the machine is
not working but the engine is running, avoid
lubricating or further adjusting the machine.
If the maintenance requires the running of
engine, assign two operators for teamwork and
keep contact with each other.
One operator must sit in the driver seat to get
ready to stop the engine immediately when
necessary. This operator must pay special
attention not to touch any joystick or pedal,
unless it's absolutely necessary.
The other operator for the maintenance must
keep the body and clothing away from motion
parts of machine.
1-26