Glossary - WAGO 752 Owner's Manual

9 Glossary

Actuator
Base Module
Electronic Module
Fieldbus controller board
Group
Input Interface
I/O addresses
I/O data
I/O module
I/O point
Master
Output Interface
Sensor
Slave
Fieldbus Dependent I/O Module
INTERBUS
Device driven by the I/O module.
Wiring level to connect the supply, the fieldbus con-
ductors and the sensors and actuators.
Plug-in component from the WAGO-I/O-SYSTEM
752
[Master]
Bus master which, as a higher ranking unit, controls
the data transmission on the bus. It interrogates the in-
put and status values of the slave devices and trans-
mits output and control data to them.
Processing unit for the interrogation of and access to
the decentral fieldbus equipment. It is the fieldbus
master which co-ordinates the bus traffic and transfers
the data to a control system.
[Input / output group, connection group]
General grouping of I/O channels. With their 8 chan-
nels, outputs form a supply group.
INTERBUS connection from an upstream bus slave.
Electrically isolated interface.
[I/O register]
Input / output area(s) for the I/O data
Input / Output data
Any fieldbus device from the WAGO-I/O-SYSTEM
752 series consisting of a base module and an elec-
tronic module for the recording and output of digital
signals.
Input / output point, signal input or output
Fieldbus controller board
INTERBUS connection to a downstream bus slave.
[Generator, initiator]
Device interrogated by the I/O module.
Bus slave addressed by a fieldbus master.
Glossary • 35