3.2.4. Ethernet
connector
Table 11: Ethernet connector X2 and X3
Pin
Signal
1
DA+
2
DA-
3
DB+
4
DC+
5
DC-
6
DB-
7
DD+
8
DD-
Cable (according to chapter 2.2/ EMC): smaller 30 m,shielded, min. Cat-5e
3.2.5. HDMI
connector
The device has a type C HDMI socket (HDMI mini). The DDC data bus is available, CEC is not available.
Use a high quality HDMI cable which is double shielded with a cable length of less than 3m.
Otherwise, compliance with the applicable EMC standards cannot be guaranteed.
Kontron recommends the use of a certified "Premium High Speed HDMI" cable with the
appropriate label from HDMI Licensing Administrator Inc.
Kontron is HDMI Adopter (Version 1.4) and pays the corresponding license fees to HDMI
Licensing Administrator Inc.
HDCP (High-bandwidth Digital Content Protection) is not supported.
3.2.6. USB 2.0 Host:
The pin assignment corresponds to the USB 2.0 standard, connector type A. The connected USB cable must be
shielded and have a cable length of less than 3m.
www.kontron.com
X2 and X3
Comment
TX
TX
RX
BI
BI
RX
BI
BI
X7
connector
X4
Control Unit CUmini 5x-2x0x - Rev. 1.A
// 22