Right Seal, Replace - Audi Q5 2008 Repair Manual

Audi Q5 2008 ➤ , Audi Q5 China 2010 ➤
8-Speed Automatic Transmission 0BK AWD - Edition 04.2017
– Replace the O-ring -arrow-.
– Insert the differential into the transmission housing.
If the tapered roller bearing outer race and the shim have fallen
out of the front final drive cover:
– Lubricate the shim and tapered roller bearing outer race with
gear oil and insert them into the front final drive cover as far
as the stop.
– Tighten the front final drive cover bolts. Refer to
⇒ Fig. ""Front Final Drive Cover - Tightening Specifications
and Sequence"" , page 148
– Install the left flange shaft. Refer to
⇒ "4.1 Left Flange Shaft, Removing and Installing",
page 172 .
– Install the right flange shaft. Refer to
⇒ "4.2 Right Flange Shaft, Removing and Installing",
page 173 .
– Add axle oil to the transmission after repair. Refer to
⇒ "2.4 Gear Oil, Draining and Filling", page 158
3.2

Right Seal, Replace

Special tools and workshop equipment required
♦ Used Oil Collection and Extraction Unit - VAG1782-
♦ Puller - Seal Lever - VW681-
♦ Seal Installer - Flange Seal - T40189-
Procedure
Note
Clean working conditions for the automatic transmission. Re‐
♦
fer to ⇒ "3.1 Clean Working Conditions, Guidelines", page 5
General repair instructions. Refer to
♦
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
⇒ "3.3 General Repair Information", page 6
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Place the -SMN372500- under the transmission.
– Remove the right flange shaft. Refer to
⇒ "4.2 Right Flange Shaft, Removing and Installing",
page 173 .
170
Rep. Gr.39 - Final Drive, Differential
.
.
.
.