QMS 2060 Reference page 88

Note: The printer is automatically restarted after this menu change.
»
The results of Quick Config depend on the amount of memory
installed, the resolution used for printing, paper size, and if the
duplexer is installed.
» Note: This menu will only appear if there is no hard disk installed in
the printer or if Enable Disk Swap is turned off. The 1200 dpi selection
will only appear if the 1200x 1200 dpi Multi-Res daughterboard is
installed.
Menu
Choices
Menu
Choices
Menu
Choices
Note
Enable Disk Swap gives your printer virtual memory capability for all
memory clients through the creation of a "swap file" on the printer's
hard disk. The printer uses this file as an extension of its memory. As
the physical RAM fills, the printer can swap the contents to the hard
disk file to allow more space. This file swapping between disk and
RAM occurs at various times throughout the printing process and is
completely transparent.
» Note: The printer must have a hard disk to take advantage of this
feature. If there is no hard disk installed, this menu does not appear.
Menu
Choices
Administration/Memory/Quick Config/300dpi
Letter/A4, Legal, 8.5x13, 11x17, 12x19, 13x22, 13x26,
Universal, A5, A3, B5, B4, Statement, Executive
Administration/Memory/Quick Config/600dpi
Letter/A4, Legal, 8.5x13, 11x17, 12x19, 13x22, 13x26,
Universal, A5, A3, B5, B4, Statement, Executive
Administration/Memory/Quick Config/1200dpi
Letter/A4, Legal, 8.5x13, 11x17, 12x19, 13x22, 13x26,
Universal, A5, A3, B5, B4, Statement, Executive
Under the Quick Config option documented on the advanced
status page you will see "****". This option isn't user-
definable. Quick Config configures memory depending only
on the resolution and paper size.
Administration/Memory/Enable Disk Swap
Off—Don't enable disk swapping.
On—Enable disk swapping.