QMS 2060 Reference page 72

Sets the point size for scalable default fonts in units of hundreths of a
point. For example, a 24 point default point size is selected by enter-
ing 2400. The smallest increment allowed in point size is .25 point (for
example, 8.5 point and 8.75 point fonts are allowed, but 8.6 point is
not).
Menu Administration/Emulations/PCL5E/Point Size x100
Choices 00025-99975 (0.25-999.75 points)
Default 01200 (12 points)
Notes If the font is not scalable or if a bitmap font is specified, the
setting is ignored.
Allows you to control the PCL 5e print environment across print jobs.
Menu
Administration/Emulations/PCL5E/Retain Temporary
Choices Off, On, On Compatibility
Off—Resets PCL to its default state at the end of each PCL
print job, executes an implicit <ESC>E at the start and end
of the job, and deletes any temporary fonts, macros, and
patterns.
On—Resets PCL to its default state at the end of each PCL
print job. Temporary fonts, macros, and patterns from
previous PCL jobs are retained in memory after the print
job has completed. You can recall these downloaded fonts,
macros, or patterns from within your PCL file without
having to download them again.
On Compatibility—Retains the entire state of PCL as well as
the temporary macros, fonts, and patterns from previous
PCL jobs when jobs of other emulations are printed
between PCL jobs.