Paper Type - QMS 2060 Reference

Default Off
Notes The available range of plotter units for a particular media size
is only partially determined by setting the Expand Mode to On.
When the printer/plotter senses the media size it automatically
sets the hard clip limit to 15mm on three sides and 39 mm on
the fourth. If Expand Mode is On, then the hard clip limits are
set to 5mm on three sides and 29 mm on the fourth side. This
is what allows you to define a larger imageable area.
The HP-GL emulation senses the media type if the paper type
is set to Scale to Paper. It is also possible to have the HP-GL
emulation use a particular media size by setting Original Paper
Type through the control panel or by using a Document Option
Command.
Identifies the original image's paper size.
Menu
Administration/Emulations/HPGL/Paper Type
Choices A—(8.5''x 11''—216 x 279 mm),
A0—(33.11'' x 46.81''—841 x 1189 mm)
A1—(23.39'' x 3.11''—594 x 1189 mm)
A2—(16.54'' x 23.29''—420 x 594 mm)
A3—(11.69'' x 16.54''—297 x 420 mm)
A4—(8.27'' x 11.69''—210 x 297 mm)
B—(11'' x 17''—279 x 432 mm)
C—(17'' x 22"—431.80 x 558.80 mm)
D—(22'' x 34''—558.80 x 863.60 mm)
E—(34'' x 44''—863.60 x 1117.60 mm)
C ARCH
D ARCH
E ARCH
Scale to Paper
Default Scale to Paper