Printer-Host Communication; Interface - QMS 2060 Reference

This menu contains several options that allow you to configure the
printers communication parameters to match the host and application
parameters.
Note: This section contains information on the Timeouts, Parallel and
»
Network menus. For information on printer-host communication using
the Ethernet interface or any options located under the CrownNet
submenu (Administration/Communications/Network /CrownNet), see
the QMS CrownNet System Administrator's Guide 
The Timeouts options limit the amount of time the printer waits on
transmission from the host for various types of data.
The PostScript emulation timeout is the maximum number of seconds
the PostScript emulation waits for incoming data.
Menu
Choices
Default
Notes
Administration/Communications/Timeouts/PS Wait Timeout
00000-99999
00030 (30 sec.)
A value of 00000 is the same as infinity (no timeout).
The job is closed and the next job in the queue begins if all of
the following occur:
No additional data is received during the specified
period of time.
The interface didn't time out.
An EOD (end-of-document commands) was not
seen.
When a print job is sent from a Macintosh, the PS Wait
timeout is automatically changed to 00300 (5 min.).
Large print jobs, such as those generated by graphics or
computer-aided design applications, require timeouts of
00300 (5 min.).