QMS 2060 Reference page 59

Chaining Media Inputbins
You can "chain" inputbins so that when the first inputbin empties, the
printer automatically draws media from another inputbin.
Menu
Choices
Default
Media Orientation
While you can usually specify the orientation of a print job in your
application, if you consistently use a certain media orientation, you
can set this in the Operator Control/Orientation menu.
Menu
Choices
Default
Selecting Media Size
The multipurpose tray must be adjusted to accept different media
sizes. See the instructions for adjusting the tray media sizes in chap-
ter 2, "Consumables," of the Operation manual.
Printer Configuration
Operator Control/Inputbin
On—Switch to the next inputbin with the same size and type of
media when the default inputbin is empty.
» Note: Make sure the two inputbins use the same size
media.
Off—Don't switch inputbins; use only the default inputbin.
On Any—Switch to the next inputbin with any size and type of
media when the default inputbin is empty.
On
Operator Control/Orientation
Portrait—Vertical
Landscape—Horizontal
Portrait
Media Orientation
4-23