Removing The Front Bezel - Agilent Technologies 53150A Service Manual

1
2
3
CAUTION
Chapter 3 Replacing Assemblies

Removing the Front Bezel

Removing the Front Bezel
Use the following procedure to remove the front bezel:
Remove the shroud hardware and slide the shroud back far enough to
fully expose the front bezel, or remove the shroud completely (see
"Removing the Shroud" on page 3-8).
Remove the four 4-40 x 3/16-inch self-locking flathead machine screws
that attach the front bezel to the front panel (two on top and two on
the bottom as shown in Figure 3-10).
Front
Bezel
Screws
Figure 3-10. Front Bezel Screws
Carefully slide the front bezel off the front panel.
When reattaching the front bezel to the front-panel assembly, do not
tighten the screws excessively to prevent damage to the bezel.
Assembly Level Service Guide
Front
Bezel
Screws
3-11