Flame Tamer Configuration - Masport MB Owner's Manual

The Flame tamers are required to be inserted in to the BBQ directly above the stainless steel Burner tubes and under the 2 x Grills
(Flame tamers are not required under the Plate), there are location points for these to fit in to.
Shown in photos 3 & 4 are the stainless steel burner tubes of the BBQ and depending on which Grill & Plate configuration used,
the Flame tamers are to be placed so that they sit directly over these Burners. Whilst different Burners are exposed due to the
configuration of the Grills & Plate, the quantity of Flame tamers required remains at four.
Photo 3 (note 4 Flame tamers required)
**Please note that Flame tamers are not required underneath the Plate.
STEP 19
Assemble the cylinder bracket. Please note that the support bar is mounted on the inside of the cabinet and the cylinder bracket is
mounted on the outside (See Fig. 1). Install the igniter battery (See Fig. 2).
NOTE:
Before operating this appliance LEAK TEST ALL JOINTS
Read thoroughly the information on assembling the hose & regulator and also the section on Leak Testing.
To Change the igniter battery, unscrew igniter button cap counter clockwise to remove. Remove battery from the battery compartment,
replace with a new alkaline "AAA" size battery. Install battery with negative end in first, screw igniter button cap clockwise into place.
48
546001.A.6 - July 17, 2019

FLAME TAMER CONFIGURATION

Photo 4 (note 4 Flame tamers required)
Fig. 2
Unscrew igniter button cap
by turning counterclockwise.
Install AAA battery with
negative end inserted first.
Screw back on the igniter
button cap turning clockwise.