Abs Fault Warning Lamp - MG Hector Owner's Manual

an emergency running procedure so that you
can continue the trip. However, we advise you
to go to the nearest MG Authorised Service
Center for fault removal as soon as possible. If
MIL illuminates for a while and then goes out, it
is normal, not indicating any system fault.
Caution
If MIL illuminates, it indicates a fault that
must be noted. Continuous driving after
MIL has illuminated can cause damage to
the emission control system, and reduce
fuel economy and vehicle controllability.
We advise you to go to the nearest MG
Authorised Service Center for vehicle
repair as soon as possible.

ABS Fault Warning Lamp

The ABS warning lamp will illuminate
immediately the ignition switch is turned on. It
indicates that the system is conducting self-
inspection and the warning lamp bulb can
work normally. The warning lamp goes out
several seconds later.
When the ABS warning lamp gets into the
following states, please consult the nearest
MG Authorised Service Center.
Not illuminated as the ignition switch is
Ÿ
turned on
Ÿ Always illuminated
Ÿ Illuminated during driving
INSTRUMENTS AND CONTROLS
If the ABS warning lamp illuminates during
driving, it indicates possibility of an ABS fault.
Though the vehicle can run normally without
ABS function, but we strongly advise you to go
to the nearest MG Authorised Service Center
for ABS inspection and necessary repair.
Caution
Illuminated ABS warning lamp can also
indicate that the brake cannot work
normally. If you fail to keep the brake in
an agreeable working condition, collision
may happen and as a result, personal
injuries, and damage to the vehicle or
other properties can occur.
87