Hazard Warning Lamp - MG ZS Series Manual

2 The vehicle is powered and the speed is above 25mph
(40km/h).
3 The rear fog lamps are not turned on.
When the smart main beam system is enabled, the auto
main beam indicator on the instrument pack illuminates.
The main beam lamps will remain on under automatic
control until any of the following conditions occur:
• The system detects the headlamps of approaching
vehicles.
• The system detects the tail lamps of vehicles ahead.
• The surroundings become bright enough not to require
main beam.
• The vehicle speed drops below the 25mph (40 km/h)
threshold.
The system will temporarily suspend the smart main beam
function once the following conditions are met:
With the smart main beam system enabled, instantaneously
pull the lighting lever towards the steering wheel, the smart
main beam function will be temporarily suspended and it
will recover after the switch is released.
INSTRUMENTS AND CONTROLS
Note: Continuously operating the main beam switch
within 2 seconds will retain the main beam lamps
under automatic control.
The smart main beam function uses data from the front
view camera, always keep the windscreen clean and
free from residue in this area to maintain optimum
performance of this system. Any damage in this area,
such as stonechips must be repaired at the earliest
convenience.

Hazard Warning Lamp

Press the hazard warning lamp button
the hazard warning lamps. The turning signal lamps and
direction indicator lamps will flash together. Press the
button again to switch off the hazard warning lamps. All
turning signal lamps and direction indicator lamps will stop
flashing. For more details and location refer to 'Emergency
Information' 'Hazard Warning Devices'.
IMPORTANT
to turn on
1
47