Table of Contents
Advertisement
VEHICLE SERVICE & MAINTENANCE
Rear Towing Hook
There is a hole cover on the left side of the
rear bumper of the vehicle. Open it and the
fixing hole for hook installation can be seen.
Take out the towing hook and install it into the
fixing hole. Rotate the towing hook clockwise
to tighten it completely and insert a socket
wrench into the hook hole to assist tightening.
Be sure that the towing hook is installed firmly
before towing the vehicle.
Do not tow vehicles that are heavier than this
vehicle; otherwise, it may damage the vehicle
or cause accidents.
194
Note
The vehicle may be damaged when it is
towed by ropes. To reduce damage:
Ÿ
The towing hook must be used when
other traction devices are not available.
The vehicle shall be towed from the
Ÿ
front only.
Keep the traction rope out of contact
Ÿ
with the bumper.
Make sure that both ends of the
Ÿ
traction rope are firmly secured on the
towing hook. Pull the traction rope for
inspection.
Ÿ
Drive the vehicle at a low speed and
avoid sharp turning.
Note
The vehicle may be out of control when it
is towed by ropes.
To reduce damage:
Ÿ
The towing distance shall not be too
long, and the vehicle should be towed
at a low speed.
Ÿ
Do not tow the vehicle if the wheel,
transmission, axle, steering or brake
damage is damaged.
Ÿ
Do not remove the key from the
ignition switch; otherwise, the steering
will be locked so that the vehicle
cannot turn.
Caution
The towing speed shall not exceed 30
Km/h, and the towing distance shall not
exceed 40 Km. When long-distance
towing is required, it is suggested to
contact the MG Authorised Service
Center or a professional towing service
company for help.
Caution
CVT models are not allowed to be towed
and must be transported by platform
trailer otherwise the transmission will be
damaged.
Advertisement
Table of Contents
